NEC Express5800/B120b, User Manual

Page: 104 / 382

4-54 Configuring Your Server
Default settings and their explanation
Item Default Description Change
Battery Backup Present
None Displays Properties of additional
battery.
•
When battery is installed: Present
•
When battery is not installed: None
–
Set Factory Defaults No – Prohibited *1
Cluster Mode Disabled – Prohibited
Rebuild Rate 30 Recommended value: 30 Permitted
BGI Rate 30 Recommended value: 30 Permitted
CC Rate 30 Recommended value: 30 Permitted
Reconstruction Rate 30 Recommended value: 30 Permitted
Controller BIOS Enabled – Prohibited
NCQ Disabled – Prohibited
Coercion Mode None – Prohibited
S.M.A.R.T Polling 300 – Prohibited
Alarm Control Disabled Disabled: Does not issue an alarm.
Enabled: Issues an alarm.
Silence:
Stops an alarm if beeped.
Permitted *2
Patrol Read Rate 30 Recommended value: 30 Permitted
Cache Flush
Interval 4 – Prohibited
Spinup Drive Count 2 – Prohibited
Spinup Delay 12 – Prohibited
StopOnError Disabled – Prohibited
Drive Powersave Disabled – Prohibited
Stop CC On Error No
Yes Specify the operation at error detection
in Consistency Check.
No: Recover and resume.
Yes: Abort Permitted
Maintain PD Fail
History Enabled – Prohibited
Schedule CC Supported Set the scheduled consistency check. Permitted
*1 Do not perform "Set Factory Defaults". If performed, the NEC's factory-set value will no longer
be restored.
*2 If Alarm Control is set to "Enabled", the server issues an alarm sound when the VD is degraded
due to failure of hard disk drive.
How to change setting value
On [Controller Properties] screen, change a parameter to desired value, and then click [Submit] at
the center of the screen to determine the new value.