NEC Express5800/B120b, User Manual

Page: 35 / 382

General Description 2-11
Virtual LCD indications when STATUS lamp is flashing in red
On-screen message Description Action
Proc 1 IERR An error was detected in CPU#1.
Proc 2 IERR An error was detected in CPU#2.
WDT Timeout Watchdog timer timeout error
occurred.
WDT Power Down Forcedly powered off due to
watchdog timer timeout error.
SMI Timeout A timeout error occurred while the
system management interrupt
process is in progress.
Turn of the power once and then
on again.
If an error message appears on
POST screen, take note of the
message, and contact your service
representative.
If no error message appears,
check the IPMI information by
using the Off-line Maintenance
Utility.
ErrPause in POST The system is waiting for key entry
due to serious POST error. Check the error message on
POST screen, take note of it, and
contact your service
representative.
DUMP Request ! Under memory dump request Wait until dump collection
completes.
CPU1_DIMM U-Err An uncorrectable memory error was
detected on CPU1_DIMM.
CPU2_DIMM U-Err An uncorrectable memory error was
detected on CPU2_DIMM.
Check installation status DIMM.
If the same error persists, contact
your service representative.
Proc Missing No CPU is installed in slot CPU#1.
Proc1 Config Err The CPU installed in the CPU#1 slot
is unsupported or its combination is
illegal.
Proc2 Config Err The CPU installed in the CPU#2 slot
is unsupported or its combination is
illegal.
Check installation status of CPU.
If the same error persists, contact
your service representative.
MEZ1 Power Fault An error was detected in power
circuit of mezzanine card installed in
Type 1 slot of CPU blade.
MEZ2 Power Fault An error was detected in power
circuit of mezzanine card installed in
Type 2 slot of CPU blade.
Check installation status of
mezzanine card.
If the same error persists, contact
your service representative.
IOH Thermal Trip Forced power-off occurred due to a
thermal error in chipset on CPU
blade.
Proc1ThermalTrip Forced power-off occurred due to a
thermal error in CPU#1.
Proc2ThermalTrip Forced power-off occurred due to a
thermal error in CPU#2.
Proc1 Therm % 09 A high temperature error was
detected in CPU #1.
Proc2 Therm % 09 A high temperature error was
detected in CPU #2.
CPUx_DIMMyTemp09 A high temperature error was
detected in DIMM. x denotes CPU
number, and y denotes DIMM slot
number.
AmbientTempAlm09 A high temperature error was
detected in CPU blade.
Check installation status of the
heat sink on the CPU blade.
Check if fans in Blade Enclosure
work normally.
Refer to the User’s Guide of the
Blade Enclosure to make sure that
the sufficient number of fans are
installed in correct locations.
Check if the fans and CPU blades
are installed in correct locations.
Check if the ambient temperature
of installation location satisfies the
operation guarantee condition.
If the same error persists, contact
your service representative.