1-10 Notes on Using Your Server
CAUTION
Hot surface
Immediately after the server is powered off, its internal components such as
hard disks are very hot. Leave the server until its internal components fully
cool down before installing/removing any component.
Make sure to complete board installation.
Always install a board firmly. An incompletely installed board may cause a
contact failure, resulting in smoking or fire.
Protect the unused connectors with the protective cap.
The unused power supply cable connectors are covered with the protective cap
to prevent short circuits and electrical hazards. When removing the power
supply cable connector from the internal devices, attach the protective cap to the
connector. Failure to follow this warning may cause a fire or an electric shock.
Do not touch any electrical components inside the server during the hot-swap
replacement.
All power flows inside the server while the hot-swap replaceable components
(PCI add-in cards, hard disk, cooling fan, and power supply). Do not touch the
electrical components inside the server to avoid an electric shock.
Summary of Contents for Express5800/140Rc-4
