NEC Express 5800/120Lg, Service Manual

Page: 116 / 204

4-50 Disassembly and Reassembly
Front Bezel and Front Bezel Hinge (Tower-
Based System)
Your server system contains a front bezel that covers the front of the chassis.
The bezel is secured to the front of the chassis by metal pins located at the top
and bottom of a front bezel hinge. To remove the front bezel, the two metal pins
must be removed from the bezel hinge.
To remove the front bezel and front bezel hinge (see Figure 4-48 and
Figure 4-48), perform the following procedures:
1. Prepare your system for disassembly. See Preparing Your System for
Disassembly and Reassembly earlier in this chapter.
2.
Remove the metal pin (B) from the top of the bezel hinge (D) by pushing in
on the flexible bezel pin tab (C) and pulling the pin down and out of the
bezel hinge. See Figure 4-48.
3. Allow the bezel (A) to drop down so that it disengages from the bottom of
the bezel hinge and remove the bezel.
4.
Remove the metal pin from the bottom of the bezel. Remove the front bezel.
A
D
B
C
A Front bezel
B Metal pin
C Flexible bezel pin
tab
D Bezel hinge
Figure 4-48. Removing the Front Bezel