![background image](http://html.mh-extra.com/html/nec/express-5800-120lg/express-5800-120lg_service-manual_251153186.webp)
D-4 Internal Cabling Diagrams
Installing a SCSI File Device
With the standard configuration, you need an optional SCSI controller and internal
SCSI cable to install a file device.
Set SCSI IDs as shown in the above figure. Set the terminating resistor
(Enabled/Disabled) for the last-connected device in the SCSI chain. Set "Disabled" for
all the middle devices. A terminating connector may be installed depending on the
internal SCSI cable. If the SCSI cable ends with a terminating resistor, set "Disabled"
for all the terminating resistors of connected devices. For the settings, see the manual
provided with each device.
A file device needs settings such as a SCSI transfer rate. For the transfer rate, see the
manual provided with the file device. Use the BIOS utility of the SCSI controller to
make the settings. For details, see the manual provided with the SCSI controller.
An onboard Ultra320 SCSI connector can be used to connect with internal SCSI file
device.
SCSI ID1
CD-ROM
SCSI ID0
5.25-inch
device bay
System board
PCI #1
PCI #2
PCI #3
PCI #4
PCI #5
PCI #6
SCSI
Floppy disk
IDE
IDE
Floppy disk
drive
ID5
ID4
ID3
ID2
ID1
ID0
SCSI cable
IDE cable
Floppy disk drive cable
SCSI controller board
SCSI cable (optional)
Terminator
Summary of Contents for Express 5800/120Lg
