NEC Express 5800/120Lg, Service Manual

Page: 107 / 204

Disassembly and Reassembly 4-41
PCI Boards
The server contains six slots into which PCI boards can be inserted.
See Figure 4-42.
IMPORTANT:
PCI boards are easily affected by static electricity.
Handle a PCI board after making your body contact with a metallic frame
section of the server to discharge the static electricity on your body. Do
not make bare hands contact with terminals and components on the PCI
board. In addition, do not put the PCI board on a desk directly. See
"Static Precautions" in this chapter for details of the static electricity.
NOTE:
When a PCI board is installed, removed, or removed from the
present slot and then installed in another slot, modify the detailed settings
including the interrupt lines (IRQ) by using the BIOS setup utility SETUP if
necessary. See Chapter 4 for the settings of the interrupt line states and
I/O spaces at the shipment of the server.
System Board
Figure 4-42. PCI Slot Designations
*1 The system operates at the rate of 33 MHz when PCI boards operating only at 33 MHz are installed in these
slots.
*2 Do not install a set of PCI boards providing a specific function to extend over both the 64-bit and 32-bit PCI
buses.
PCI board slot #1
PCI board slot #2
PCI board slot #3
PCI board slot #4
PCI board slot #5
PCI board slot #6
64-bit/100 MHz
*1
32-bit/33 MHz
*2