NEC Express 5800/120Lg, Service Manual, Page: 130 / 204

4-64 Disassembly and Reassembly
10.
Snap the replacement I/O shield into place in the rear panel.
11. Install the system board following procedures previously described in this
chapter.
12.
Install the left-hand side access panel.
LED/Switch Assembly
Your server system contains a front panel that houses the LED/switch assembly.
You must open the front bezel to access the front panel. To remove the front
panel LED/switch assembly, perform the following procedures:
1. Prepare your system for disassembly. See Preparing Your System for
Disassembly and Reassembly earlier in this chapter.
2.
Remove the left-hand side access panel of the system chassis following
procedures previously described in this chapter.
3.
Remove the front panel following procedures previously described in this
chapter. See
Front Panel earlier in this chapter.
4. Remove the power switch, reset switch and dump switch from the front of
the chassis. To release these switches, squeeze their two plastic snap tabs
together and slide the switch back until it is free of the chassis.
See Figure 4-59, A.
A
B
C
A
Switches (3)
B Cable
C
System Board Connector
Figure 4-59. Replacing the LED/Switch Assembly