NEC EXP320A, User Manual

Page: 302 / 427

Installing and Using Utilities 5-77
Setup of System Operation
The following properties can be set as the operation setup of the whole system.
„
Quick dump that is harvested at the same time of reboot
If “Enable” is selected for this item, dump is collected as the system reboots when an error
occurs in the system. When “Disable” is selected, dump is collected by the OS standard dump
function.
㩷
The default value is “Enable.”
IMPORTANT:
To use the quick dump function, refer to “Make Settings for Failure Management” in the
User’s Guide (Setup) to set “Complete memory dump” for the memory dump setting and
reboot the system. When the setting is not set to “Complete memory dump”, the standard
memory dump function is performed even if the quick dump setting is set to “Enable” In
addition, the standard memory dump function is used when “Complete memory dump”
cannot be specified because mounted memory exceeds 2GB.
„
Auto firmware update
If “Enable” is selected for this item, the BIOS of the new CPU module is updated to the BIOS
of the existing CPU module to match with each other. If “Disable” is selected, the BIOS of the
new CPU module is not updated automatically.
The default value is “Enable.”
„
Auto module start
If “Enable” is selected for this item, modules will be put into the duplex mode automatically
when mounting both modules and restarting the system. If “Disable” is selected, the modules
will not be in the duplex mode.
The default value is "Enable."
㩷
㩷