![background image](http://html.mh-extra.com/html/nec/exp200/exp200_user-manual_251123091.webp)
Configuring Your Server 4-29
CONFIGURING MOTHER BOARD JUMPERS
You can use the following procedure to clear the CMOS data in the server.
IMPORTANT:
Clearing the CMOS data resumes the factory-set configuration data.
Do not change any other switch settings. Any change may cause the
server to fail or malfunction.
Clearing CMOS sets [SATA RAID Enabled] in the [Advanced] -
[I/O Device Configuration] menu to [Disabled]. If the SATA hard
disk drives are installed in your server and the onboard SATA
RAID feature is used, change the parameter of the [SATA RAID
Enabled] from [Disabled] to [Enabled] before exiting BIOS Setup.
Leaving this parameter as the factory-set value (Disabled) may
destroy the data in hard disk drive.
NOTE:
To display the [SATA RAID Enabled] menu, select
[Advanced] - [I/O Device Configuration] - [SATA Controller Mode
Option] - [Enhanced].
Mother board
Protect
Clear
Summary of Contents for EXP200
