9-34 Upgrading Your Server
IDE Device
1.
Provide the proper setting for the device.
See the table below for the settings of the devices which can be installed in the device bay.
Device
Setting
IDE device
Termination resistance: OFF
2.
See the section "Preparing for Installation and Removal" described earlier to prepare.
3.
Remove the left side cover and front mask as described earlier in this chapter.
4.
Remove all the cables from the factory-installed CD-ROM and floppy disk drives and the
devices installed in the device bay.
5.
Remove the factory-installed CD-ROM drive with the release tabs on the both sides of the
drive pushed.
6.
Secure the device to be installed to the rail with two screws provided with the device.
Summary of Contents for EXP200
