![background image](http://html.mh-extra.com/html/nec/exp200/exp200_user-manual_251123067.webp)
Configuring Your Server 4-5
Configuration Examples
The following describes examples of configuration required to use software-link features or for
system operations.
Time and Date Settings
You can also change the time and date settings via the operating system commands.
Select [Main] - [System Time].
Select [Main] - [System Date].
Link with Management Software
To control power supply of the server with NEC ESMPRO Manager via the network
Select [Advanced] - [Advanced Chipset Control] - [Wake On LAN/PME] - [Enabled].
Select [Server] - [AC LINK] - [Stay Off].
ATA Drive Settings
To check the ATA drives connected with the onboard ATA channels.
Select [Main] - [Primary IDE Master], [Primary IDE Slave], [IDE Secondary/Master], and
[IDE Secondary/Slave].
To configure the RAID drive.
Select [Advanced] - [I/O Device Configuration] - [SATA Controller Mode Option] -
[Enhanced]. Then select [Advanced] - [I/O Device Configuration] - [SATA RAID
Enabled] - [Enabled], and use the RAID configuration utility (see "RAID Configuration
Utility" in this chapter).
IMPORTANT:
Be sure to set to [Enabled] after executing [Load
Setup Defaults] or CMOS clear. Leaving this parameter as the factory-
set value (Disabled) may destroy the data in hard disk drive.
UPS
To link power supply with the UPS
To power on the server when power is supply from the UPS
Select [Server] - [AC LINK] - [Power On].
To keep the server off-powered even when power is supplied from the UPS
Select [Server] - [AC LINK] - [Stay Off].
Summary of Contents for EXP200
