![background image](http://html.mh-extra.com/html/nec/exp200/exp200_user-manual_251123160.webp)
5-54 Installing the Operating System with Express Setup
Notes
The following explains general notes on HostRAID:
For notes on the BIOS setup utility, refer to Chapter 4 of this manual. For notes on ASM, refer to
"Adaptec Storage Manager™ User's Guide".
NOTE:
You may view or print the Adaptec Storage Manager™ User's
Guide from the NEC EXPRESSBUILDER CD-ROM.
Only use the HostRAID drive as a system drive.
Only a hard disk drive can be connected to a channel with which HostRAID is enabled
through the BIOS setup utility.
To connect a device other than a hard disk drive, disable HostRAID and use it as the
standard SATA.
In addition to driver installation, ASM installation is mandatory for using HostRAID
functions. For the installation of ASM, refer to the "Adaptec Storage Manager™ User's
Guide."
If you replace a hard disk drive being used with HostRAID, please replace the hard disk
drive after power-off of the system. Be sure to check the PORT number of the hard disk
drive to be replaced in ASM in advance.
HostRAID does not permit the use of the standby/hibernation mode of ACPI functions.
Use ASM to maintain HostRAID, but do not use any other utilities.
If the following messages are included in the application log or log generated by the ASM,
your RAID system operates normally.
–
Spare test failed for pool spare (bus=%2, ch=%3, id=%4)
–
Test of all spares completed with %1 failures
To start the system from the created array, be sure to create a bootable array. See Chapter
4 "Setting of Bootable" in this manual.
If you do not create a bootable array, the memory dump can not be collected when a
trouble occurs.
Summary of Contents for EXP200
