![background image](http://html.mh-extra.com/html/nec/exp200/exp200_user-manual_251123219.webp)
Troubleshooting 8-11
POST fails to complete:
T
Is the DIMM board installed?
→
At least one DIMM boards are required for operation.
T
Is the memory size large?
→
The memory check may take a few seconds if the memory size is large. Wait for a
while.
T
Did you perform any keyboard or mouse operation immediately after you started the
server?
→
If you perform any keyboard or mouse operation immediately after start-up, POST
may accidentally detect a keyboard controller error and stops proceeding. In such
a case, restart the server once again. Do not perform any keyboard or mouse
operation until the BIOS start-up message appears when you restart the server.
T
Does the server have contains appropriate memory boards or PCI devices?
→
Operation of the server with unauthorized devices is not guaranteed.
Fail to access to internal or external devices (or such devices fail to operate):
T
Are cables properly connected?
→
Make sure that the interface cables and power cord are properly connected. Also
make sure that the cables are connected in the correct order.
T
Is the power-on order correct?
→
When the server has any external devices connected, power on the external
devices first, then the server.
T
Did you install drivers for connected optional devices?
→
Some optional devices require specific device drivers. Refer to the manual that
comes with the device to install its driver.
T
Is BIOS configuration correct?
→
Some devices connected to the serial or parallel port may require I/O port address
or operation mode settings. Refer to the manual that comes with the board for
details to make correct settings.
Summary of Contents for EXP200
