![background image](http://html.mh-extra.com/html/nec/exp200/exp200_user-manual_251123289.webp)
Internal Cabling Diagrams 10-3
Installation of SCSI Disks
If SCSI hard disk drives are added, connect the cables as shown in the figure below (the number of
connectors varies depending on the type of the SCSI cable). Install the hard disk drives in the order
of SCSI ID0, ID1, and ID2 from bottom to top. Connect the connector nearest to the last interface
cable to the hard disk drive of SCSI ID0, the next connector to the hard disk drive of SCSI ID1, the
third connector to the hard disk drive of SCSI ID2, and the last connector to the on-board SCSI
card.
5.25-inch device bay
3.5-inch device bay
Third hard disk drive
SCSI ID2
Second hard disk drive
SCSI ID1
CD-ROM drive
Floppy disk drive
Terminator
Power
supply
Mother board
Floppy disk
drive
IDE
IDE cable
FDD cable
SCSI cable
First hard disk drive
SCSI ID0
LED
connector
SCSI
controller
Unused
Summary of Contents for EXP200
