![background image](http://html.mh-extra.com/html/nec/exp200/exp200_user-manual_251123291.webp)
Internal Cabling Diagrams 10-5
To build a disk array, at least two hard disk drives are required. Use the SATA cables provided with
the disk array controller (SATA) for the connection. Remove the cables connected to the hard disk
drives and save them for future use.
IMPORTANT:
Use hard disk drives with the same capacity and performance.
Purchase the power cables separately.
To indicate the access status of the internal hard disk drives, connect the LED cable provided with
the server to the LED connector on the mother board and the disk array controller (SATA).
You can check the disk status (disk error or rebuilding of disk array) through the disk array
management utility, Web-based Promise Array Manager, coming with the disk array controller
(SATA).
5.25-inch device bay
3.5-inch device bay
Fourth hard disk drive
Third hard disk drive
CD-ROM drive
Floppy disk drive
Power
supply
Mother board
Disk array
controller
(S-ATA)
PCI #1, #2 or #5)
IDE
IDE cable
FDD cable
S-ATA cable
Second hard disk drive
First hard disk drive
LED connector
Floppy disk drive
Summary of Contents for EXP200
