![background image](http://html.mh-extra.com/html/nec/exp200/exp200_user-manual_251123285.webp)
Upgrading Your Server 9-47
5.
Make sure that the RMC is fixed with both levers on the RMC connector.
6.
Reassemble the server
7.
Turn on the server and check that the no error messages other than the following message
are displayed on the POST screen.
H/W Configuration of BMC is corrupted.
!!Update BMC H/W Configuration by configuration tool!!
!!Refer to BMC configuration manual!!
See Chapter 8 for POST error messages.
IMPORTANT:
If the RMC has not been configured, the POST will
take a long time.
8.
Insert the NEC EXPRESSBUILDER CD-ROM into the CD-ROM drive and reboot the
server. Run "Initialize Remote Management Card" to update the firmware.
Refer to Chapter 6 for details.
9.
Run BIOS SETUP utility and check to see that the menus related to the RMC, [SDR
Revision], and [PIA Revision] are displayed in [System Management] in the [Server]
menu.
If no additional menus are displayed, reinstall the RMC.
10.
In the BIOS SETUP utility, select "Yes" for [Reset Configuration Data] in the [Advanced]
menu.
This setting is required to change the hardware configuration data. See Chapter 4 for
details.
11.
Reboot the server and run NEC EXPRESSBUILDER to save system information.
Refer to Chapter 3 or 6 for details.
12.
Override installation of NEC ESMPRO Agent if installed.
To collect the system information and event log from the management PC, NEC
ESMPRO Agent must be installed in the server.
Summary of Contents for EXP200
