![background image](http://html.mh-extra.com/html/nec/exp200/exp200_user-manual_251123288.webp)
10-2 Internal Cabling Diagrams
INTERFACE CABLES
This section describes the connections of the interface cables.
Addition of Hard Disk Drive
The connection required when a hard disk drive is added is described below.
Installation of SATA Disks
If the serial ATA (SATA) hard disk drives are added, connect the cables as shown in the figure below.
Fill the drive bay with the hard disk drives from the bottom to top bay.
If two SATA hard disk drives are installed in the server, you can configure a disk array by using on-
board controller (HostRAID). See Chapter 4 for details.
5.25-inch device bay
3.5-inch device bay
Fourth hard disk drive
Third hard disk drive
Second hard disk drive
First hard disk drive
CD-ROM drive
Floppy disk drive
Power
supply
Mother board
Floppy disk
drive
IDE
IDE cable
FDD cable
S-ATA cable
Summary of Contents for EXP200
