Muratec MFX-2830, Operation Manual

Page: 382 / 471

Common
Settings
Common Settings for Copy and Fax
●
Function Settings
4-4
0/ 60
_
Clear
Lower Symbol Space
Cancel Enter
1:Not register
1 2 3 4 5 6 7 8 9 0
Q W E R T Y U I O P
_
Z X C V B N M . @
A S D
F G H
J K L
7
Enter the title.
8
Press [Enter] to complete the en-
try.
· Up to 60 characters can
be entered.
· For details of the char-
acter entry, refer to page
1-44.
· In the
MACRO
lists, up
to 40 characters from
the beginning of the title
are displayed.
Note
· Individual operations
cannot be changed once
they are entered. You
will need to return to
the beginning and per-
form the entire entry
again.
· While the entry is being
performed, any mistakes
in the operations and
changes procedures will
be also entered.
Note
When you have entered
START
....
The following message is displayed if
START
is pressed during an operation.
LTR
LTR
LGL
11x17
Doc.Type
Auto
DuplexCopy
OFF
Contrast
Auto
Zoom
100%
Finishing
No Sort
Others
Copy Ready
001
Set
Memory 100%
Yes No
Include Start/Enter?
Press [Yes] to enter the steps (operations) until
START
was pressed. Press [No] to enter the steps (operations) until the
one immediately before
START
was pressed.
●
You can use this function as follows:
Press [No] while entering a sending operation, excluding
START
in Macro. Then, when you press the corresponding
MACRO
, all the entered steps just before pressing
START
will be run. After that, delayed transmission or other set-
tings can be set.
* If you press
[Yes]
and include
START
in Macro, the fax will be sent. Therefore, such settings as delayed transmission
cannot be set.
In this case