Monitor TAD-214-W300, Installation Instructions & Operating Manual

Page: 34 / 80

30
5.14.2. - Connect all sensors Tamper connections in series to: -
One wire to a free Channel (1 to 14) and
The other to GroundOut.
5.14.3.
– N.B the selected channel will require configuring to ‘Tamper CH’
see Advanced Set Up
5.14.4.
– If a wireless sensor has a Tamper circuit which is required a free
wireless channel (15 to 24) will require configuring to ‘Tamper NC’ see
Advanced Set Up
5.15. - Wireless Transmitter
5.15.1 - Items suitable for use with a Wireless Transmitter can be
purchased as a wireless package (i.e. Sensor and Transmitter). In some
cases (e.g. PIR) the transmitter will be already fitted in the enclosure or,
for use with other sensors, with a short fly lead already connected. In
these instances installation will be as simple as inputting the transmitter
RF code into the relevant control unit channel (see Commissioning section)
and mounting the sensor .In other cases it may be possible for the
transmitter to be supplied separately.
5.15.2. - The Wireless Transmitter receives a trigger from the sensor and
transmits this signal back to one of 10 available RF Channels (Channels 15
to 24 inclusive) Each Transmitter has a unique RF code, this code can be
found on the Transmitter packaging, on the unit and inside of the unit) the
relevant Channel has to be set up including inputting this code (see
Commissioning section).
5.15.3.
– Where the transmitter is already fitted to a sensor locate and
secure the sensor in accordance with the relevant sensor instructions, for
Transmitters supplied in a separate enclosure location should be as
discreet as required whilst minimising cable run to the transmitter from
the sensor.
5.15.4. - The Wireless Transmitter should be securely mounted to a stable,
rigid surface. The cable should be securely routed to the sensor.