Monitor TAD-214-W300, Installation Instructions & Operating Manual

Page: 22 / 80

18
4.10. - Status LED
4.10.1. - An external LED can be connected to indicate its status (armed or
disarmed) along with its current GPS and GSM signal strengths.

When the system is armed the LED will flash slowly.

When the system is triggered the LED will light constantly.

When the alarm is disarmed the LED will indicate the GSM signal
strength and the number of GPS satellites in view. The LED will
flash in the following pattern:
o
Off for 4 seconds.
o
Flashes Green 1-5 times to indicate GSM signal strength.
o Off for 1 second.
o
Flashes Red 0-12 times to indicate the number of satellites
in view.
4.10.2. - Connect: -
POSITIVE / RED wire to terminal F (LED+).
NEGATIVE / BLACK wire to terminal G (LED-).
4.11. - Microphone
4.11.1. - A Microphone can be connected to the system. If the system is
phoned it auto answers after 3 rings, once ‘answered’ with the
microphone connected on board activity can be listened to. If a speaker is
also fitted (see below) a two way communication can take place.
4.11.2. - Connect: -
The 3.5mm microphone Jack Plug directly into the socket marked ‘MIC’ on
the PCB.
4.12. - Speaker
4.12.1. - A Speaker can be connected to the system. If the system is
phoned it auto answers after 3 rings, once ‘answered’ with the speaker
connected instructions/information can be passed to those on board. If a
microphone is also fitted (see above) a two way communication can take
place.