Monitor TAD-214-W300, Installation Instructions & Operating Manual

Page: 12 / 80

8
Compliance
R&TTE DECLARATION OF CONFORMITY
This is to certify that “Monitor” Systems (component products; Control
Unit TAD-260, RF Transmitter TAD-214-W300) conform with the following
standard(s) or other normative document(s),
ETSI EN 301 511, EN 301 489-
7, EN 60950-1 , following the provisions of R&TTE Directive 1999/5/EC,
when used with the manufacturer-supplied GSM antenna.
ROHS COMPLIANCE DECLARATION
This is to certify that, to the best of our knowledge based on the
information provided to us by our suppliers,
“Monitor” Systems have been
designed and manufactured to be in full compliance with the European
Union’s (EU) Restriction on use of Hazardous Substances (RoHS) Directive
2002/95/EC .
FCC
COMPLIANCE DECLARATION
“Monitor” Systems (component product; Control Unit TAD-260) contains
FCCID: MIVGSM0308. This is to certify that this device conforms with part
15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference and (2) This device
must accept any interference received, including interference that may
cause undesired operation.
Specifications may change without notice. The Monitor products are
produced in the UK by TAD Electronics.
“Monitor” systems are not safety critical products. They also cannot stop or
prevent a burglary. However, a correctly installed, set up and maintained system,
when armed will sound a siren and trigger a strobe (if fitted) and notify by SMS
message if any of the zones are triggered. The prime intent is to discourage a
would-be burglar. The manufacturers of
“Monitor” systems will not be responsible
for the failure of the alarm in preventing a burglary or any resulting/consequential
damage or loss.