Monitor TAD-214-W300, Installation Instructions & Operating Manual

Page: 36 / 80

32
6. - Install SIM Card
The Power must not be switched on during fitting or removal of the
SIM card (This includes disconnection of the internal Battery).
6.1. - Note the phone number of the SIM card, all communication to the
unit will be via this phone number. If the unit is likely to be used abroad or
contacted from abroad it is better to note in international dialling code
form (e.g. 07123456789 becomes 00447123456789), this way were ever
you are the number will be correct.
6.2. - It is a good idea to first fit the SIM card into a mobile phone to
ensure that it is registered and can successfully send text messages.
Ensure that no PIN code is set on the SIM (the phone should not ask for a
PIN after being turned on), Voice Mail should also be disabled (refer to the
SIM Card provider for instructions). After testing, the SIM can be installed
into the unit. If using a prepay SIM card it is a good idea to use one whose
balance can be checked and topped up without removing the SIM from the
unit.
6.3. - We recommend checking which service provider provides the best
coverage in the area that the boat will operate and use that service
providers SIM card. If the boat is going to be in an area for a time that
the normal service provider coverage is poor we recommend the use of a
second SIM card and swap with the normal SIM for that time. The unit will
retain all of the settings and notification phone numbers but you must
remember that to text command the alarm the phone number of the
second SIM card will have to be used.
6.4. -
IMPORTANT: Ensure power is off
and the Internal Back Up Battery is
disconnected before fitting/removing SIM.
6.5. - With the front panel of the control
unit removed, the SIM card should be
installed into the holder. Ensure that the
SIM card is correctly orientated and
pushed fully in.
The SIM card will ‘click’
into place when in the correct position.