Monitor TAD-214-W300, Installation Instructions & Operating Manual

Page: 48 / 80

44
9. - Apply the ALARMED & MONITORED label
9.1. - As an additional preventative measure it is advisable to display the
ALARMED & MONITORED label in a prominent position (should you require
additional labels they can be purchased).
9.2. - Position and check Substrate
After a suitable position has been determined, check that the substrate is
in a good condition and suitable for the label to be stuck to.
9.3. - Apply the Sticker
9.3.1. - The best way to apply the sticker using a water and washing up
liquid mixture, applied this way it will be easier to position and there will
be no unsightly air bubbles.
9.3.2. - Half fill a small bottle with cold tap water, add a small squirt of
washing up liquid and shake hard so that the water takes on the colour of
the washing up liquid and the top half of the bottle fills with suds. Pour the
fluid into a tray or plate. Remove and retain the sticker backing sheet and
dip both sides of the sticker into the fluid.
9.3.3. - Place the sticker into its position (the solution will enable free
movement to accurately position the label), cover the face of the sticker
with the retained sticker backing sheet and using a rubber squeegee or
similar, carefully squeegee the fluid from the centre of the sticker.
9.3.4. -Once all the fluid has been squeezed out dry the
excess moisture with a cloth. Within an
hour or two the sticker will
have adhered just
as well as if it
had
been
applied dry.