Mitsubishi MOTORS Outlander PHEV 2018, Owner'S Manual

Page: 224 / 457

Blind Spot Warning (BSW) (with Lane Change Assist) (if so equipped)
Features and controls 5-103
5
N00592200066
The Blind Spot Warning (BSW) is a driving
aid system that alerts the driver when another
vehicle which may not be visible through the
outside rearview mirror is traveling in the
next lane behind your vehicle.
When a vehicle in the next lane is traveling at
same speed or faster in the detection areas,
the Blind Spot Warning light in the corre-
sponding outside rearview mirror will illumi-
nate. If the turn signal lever is operated to the
side where the Blind Spot Warning light is
illuminated, the Blind Spot Warning light will
blink and the system will beep three times to
alert the driver.
Depending on the relative speed between
your vehicle and a vehicle in the next lane,
the Blind Spot Warning system will detect up
to approximately 230 feet (70 m) from your
vehicle. (Lane Change Assist)
N00592300067
The BSW uses two sensors (A) located inside
the rear bumper.
The detection areas are shown as illustrated.
Blind Spot Warning (BSW)
(with Lane Change Assist)
(if
so equipped)
WARNING
 Before using the BSW, read this entire sec-
tion to fully understand the limitations of
this system. Failure to follow instructions
could result in an accident.
 Never rely solely on the BSW system when
changing lanes. BSW is an aid only. It is
not a substitute for your safe and careful
driving. Always check visually behind and
all around your vehicle for other vehicles.
The performance of the BSW may vary
depending on driving, traffic and/or road
conditions.
Detection areas
BK0254400US.book 103 ページ ２０１７年８月１０日 木曜日 午後１時５０分