Mitsubishi MOTORS Outlander PHEV 2018, Owner'S Manual

Page: 324 / 457

HomeLink® Wireless Control System (if so equipped)
Features and controls 5-203
5
4. Press the HomeLink
®
button that was just
programmed and observe the indicator
light.
• If the indicator light continuously illumi-
nates green, programming is complete
and your device should operate when the
HomeLink
®
button is pressed and
released.
• If the indicator light rapidly flashes
green, firmly press, hold for 2 seconds
and release the programmed HomeLink
®
button. Repeat the “press/hold/release”
sequence a second time, and, depending
on the brand of the garage door opener
(or other rolling code equipped device),
repeat this sequence a third time to com-
plete the programming process. At this
point if your device operates, program-
ming is complete.
• If the device does not operate, continue
with “Programming a new HomeLink
®
”
steps 5 to 7 to complete the program-
ming of a rolling code equipped device.
5. At the garage door opener receiver
(motor-head unit) in the garage, locate the
“Learn” or “Smart” button. This can usu-
ally be found where the hanging antenna
wire is attached to the motor-head unit
(see the garage door opener manual to
identify the “Learn” button.)
6. Firmly press and release the “Learn” or
“Smart” button. (The name and color of
the button may vary by manufacturer.)
There are typically 30 seconds to initiate
step 7.
7. Return to the vehicle and firmly press,
hold for 2 seconds and release the pro-
grammed HomeLink
®
button. Repeat the
“press/hold/release” sequence a second
time, and, depending on the brand of the
garage door opener (or other rolling code
equipped device), repeat this sequence a
third time to complete the programming
process.
HomeLink
®
should now activate your
rolling code equipped device.
N00584800021
Canadian radio-frequency laws require trans-
mitter signals to “time-out” (or quit) after
several seconds of transmission - which may
not be long enough for HomeLink
®
to pick
up the signal during programming. Similar to
this Canadian law, some U.S. gate operators
are designed to “time-out” in the same man-
ner.
The indicator LED on the hand-held transmit-
ter will go off when the device times out indi-
cating that it has finished transmitting.
If you live in Canada or you are having diffi-
culties programming a gate operator or
garage door opener by using the “Program-
ming” procedures, replace “Programming a
new HomeLink
®
” step 3 with the following:
NOTE
 Some devices may require you to replace this
“Programming a new HomeLink
®
” step 3
with procedures noted in the “Gate operator /
Canadian programming” section. If the indi-
cator light does not change to rapidly flash-
ing green or continuously lit green after
performing these steps, contact HomeLink
®
at www.homelink.com
NOTE
 In the event that there are still programming
difficulties or questions, additional Home-
Link
®
information and programming videos
can be found online at www.homelink.com,
www.youtube.com/HomeLinkGentex, or by
calling the HomeLink
®
Hotline.
Gate operator/Canadian pro-
gramming
BK0254400US.book 203 ページ ２０１７年８月１０日 木曜日 午後１時５０分