Mitsubishi MOTORS Outlander PHEV 2018, Owner'S Manual

Page: 180 / 457

S-AWC (Super-All Wheel Control) (if so equipped)
Features and controls 5-59
5
N00590800026
The “4WD LOCK” mode improves the driv-
ing stability on a wet road surface or a snowy
road, etc.
To switch to the “4WD LOCK” mode, press
the 4WD lock switch while the operation
mode of the power switch is ON. To cancel
the “4WD LOCK” mode, press the 4WD lock
switch again while the operation mode of the
power switch is ON.
When the “4WD LOCK” mode is activated,
the following display will appear on the
information screen in the multi-information
display for a few seconds.
N00542501061
The S-AWC operation status can be displayed
on the information screen in the multi-infor-
mation display.
To display the status, press the multi-informa-
tion meter switch to change the information
screen.
Refer to “Information screen (when the oper-
ation mode in ON)” on page 5-135.
The S-AWC operation status is displayed.
4WD lock switch
CAUTION
 Make sure that all four tires are the same
specified size, type, and brand, and have no
significant difference in the amount of wear
for all 4 wheels. Otherwise, the S-AWC sys-
tem may not work properly, and a EV system
warning (service required) may be displayed.
NOTE
 The drive mode can be switched while driv-
ing or stopped.
S-AWC operation display
Display example
Yaw control function display
The amount of the yaw moment is displayed
as a bar graph.
A, D- Clockwise yaw moment about the
vehicle’s center of gravity
B, C- Counterclockwise yaw moment
about the vehicle’s center of gravity
Torque distribution function display
The torque distribution between the front
and rear wheels is displayed in section E of
the meter as a bar graph.
BK0254400US.book 59 ページ ２０１７年８月１０日 木曜日 午後１時５０分