Mitsubishi MOTORS Outlander PHEV 2018, Owner'S Manual

Page: 384 / 457

How to change a tire
For emergencies 8-13
8
6. Get the jack, bar and wheel nut wrench
ready.
(Refer to “Jack and tools” on page 8-6.)
N00849801545
1. Loosen the wheel nuts with the wheel nut
wrench. Do not remove the wheel nuts
yet.
2. Place the jack under one of the jacking
points (A) shown in the illustration. Use
the jacking point closest to the tire you
wish to change.
3. Rotate the jack by hand until the flange
portion (B) fits in the groove (C) at the top
of the jack.
4. Insert the bar (D) into the wheel nut
wrench (E). Then put the end of the bar
into the shaft’s jack end, as shown in the
illustration.
Slowly rotate the wheel nut wrench until
the tire is raised slightly off the ground
surface.
To change a tire
WARNING
 Set the jack only at the positions shown
here. If the jack is set at a wrong position,
it could dent your vehicle or the jack
might fall over and cause personal injury.
 Do not use the jack on a tilted or soft sur-
face.
Otherwise, the jack might slip and cause
personal injury. Always use the jack on a
flat, hard surface. Before setting the jack,
make sure there are no sand or pebbles
under the jack base.
BK0254400US.book 13 ページ ２０１７年８月１０日 木曜日 午後１時５０分