![background image](http://html.mh-extra.com/html/mitsubishi-electric/q-series/q-series_programming-manual_239984140.webp)
6 - 1
6
6 DRIVE MODULE
6. DRIVE MODULE
The drive module is the source of drive for the virtual axis (virtual main shaft, virtual
auxiliary input axis).
There are following 2 types drive module.
• Virtual servomotor ....................... Refer to Section 6.1
• Synchronous encoder ................. Refer to Section 6.2
POINT
Set the travel value of drive module so large as possible to prevent the speed
fluctuation of output module in the mechanical system program. If the travel value
of drive module is small, the speed fluctuation of output module may occur
depending on the setting for transmission module.
Summary of Contents for Q Series
