Mita PointSource Ai 3010, Service Manual

Page: 300 / 478

2AR
3-3-27
(2-2) Fitting the scanner wires
Caution: When fitting the wires, be sure to use those specified below.
Machine front: 2AR12100
Machine rear: 2AR12180 (black)
Fitting requires the following tool: Two frame securing tools (P/N: 2AC68230)
<Procedure>
• At the machine rear:
1. Insert the two frame securing tools into the positioning holes at the centers of the
scanner unit front and rear to pin the mirror 2 frame in position.
2. Secure the two frame securing tools at the machine front and rear using the two
screws for each.
3. Hook the round terminal on one end of the scanner wire onto the left catch on the
inside of the scanner unit. ·······················································································
1
4. Loop the scanner wire around the rear groove in the scanner wire pulley on the
mirror 2 frame, winding from below to above. ························································
2
5. Loop the scanner wire around the groove in the scanner wire pulley at the right of
the scanner unit, winding from above to below. ·····················································
3
Rear groove
(Machine left)
(Machine right)
4
2
5
3
1
Scanner wire spring
Wire guide
6
7
Front groove
Scanner wire drum
Catch
Scanner wire pulley
Round
terminal
Round terminal
Figure 3-3-29 Fitting the scanner wires