Mita PointSource Ai 3010, Service Manual

Page: 59 / 478

2AR
1-3-39
E
500 ms after the drive motor (DM) turns on, transfer charging (TC REM) starts.
F
When the fixing temperature reaches 175
°
C/347
°
F, the copier enters secondary
stabilization. Fixing heaters M and S (H1 and H2) are turned on and off to keep the
fixing temperature at 175
°
C/347
°
F and aging starts.
G
Copying is enabled as follows:
1. When fixing temperature at the main switch turning on is 100
°
C/212
°
F or lower
Absolute humidity is 15 g/m 3 or higher:
Copying is enabled 120 s after fixing heater M (H1) turning on.
2. When fixing temperature at the main switch turning on is 100
°
C/212
°
F or lower
The fixing temperature at the main switch turning on is 13
°
C/55.4
°
F or higher and
the ambient temperature is 18
°
C/64.4
°
F or higher:
Copying is enabled at the earlier timing of either 41 s after fixing heater M (H1)
turning on or when the copier enters secondary stabilization.
Other than the above:
Copying is enabled at the later timing of either 69 s after fixing heater M (H1)
turning on or when the copier enters secondary stabilization.
3. Other conditions than 1 and 2
Copying is enabled when the copier enters secondary stabilization.
H
10 s after copying is enabled, transfer charging (TC REM) ends.
Note: If the fixing temperature at main switch (MSW) turning on is 100
°
C/212
°
F or
lower and the absolute humidity is 15 g/m 3 or higher, transfer charging (TC
REM) ends 60 s after the copying is enabled.
I
300 ms after transfer charging (TC REM) ends, the drive motor (DM) turns off and
aging ends.
J
500 ms after aging ends, developing bias (DB REM) turns off.