Mita PointSource Ai 3010, Service Manual

Page: 293 / 478

2AR
3-3-20
(9-3) Adjusting the center line of image printing
Make the following adjustment if there is a regular error between the center lines of the
copy image and the original when paper fed from the drawer.
U034
U067
(P.3-3-41)
U403
(P.3-3-42)
U 402
(P.3-3-21)
Caution:
• Before and after performing this adjustment, be sure to perform (8) Adjusting the
position of rack adjuster.
• Check the copy image after the adjustment. If the image is still incorrect, perform
the above adjustments in maintenance mode.
<Procedure>
Yes
No
Start
Enter maintenance mode.
Enter “034” using the numeric keys.
Press the start key.
Press the interrupt key.
Press the start key
to make a test copy.
Is the image correct?
Press the start key.
The new setting is stored.
Select “LSUOUT”.
For output example 1, decrease
the value using the cursor left key.
For output example 2, increase
the value using the cursor right key.
Setting range: –5.0 - +5.0
Changing the value by 1 moves the
center line by 0.1 mm.
Initial setting: –0.5
LSUOUT: Optical axis adjustment data
LSUOUT 2: Optical axis adjustment data
for duplex copying (second face)
Press the stop/clear key.
Exit maintenance mode.
End
Correct image Output
example 1
Figure 3-3-23
Output
example 2
2AR-3