Mita PointSource Ai 3010, Service Manual

Page: 280 / 478

2AR
3-3-7
( 2 ) Replacing the upper and lower paper width switches
Replace the upper and lower paper width switches as follows.
Caution: After replacing a paper width switch, be sure to perform (8) Adjusting the
position of the rack adjuster.
<Procedure>
1. Remove the drawer.
Drawer
Figure 3-3-7
2. Remove the two screws holding the 8-pin socket from the rear of the drawer and
then the socket.
3. Detach the 8-pin paper width switch connector from the 8-pin socket.
4. Remove the three screws holding the rack adjuster.
5. While raising the drawer lift in the direction of the arrow, remove the rack adjuster.
Screws
Rack adjuster
Drawer lift
8-pin connector
Screws
8-pin socket
Figure 3-3-8 Detaching the rack adjuster
2AR-1