Mita PointSource Ai 3010, Service Manual

Page: 235 / 478

3-2-80-18
2AR-1
Mainte-
nance Description
item No.
U609
(cont.)
Setting the T2 time-out time
The T2 time-out time decides the following.
• From CFR signal output to image data reception
• From image data reception to the next signal reception
• In ECM, from RNR signal detection to the next signal reception
1. Change the setting using the numeric keys.
Description
T2 time-out time
Setting range Initial setting Change in value per step
1 to 255 60 100 ms
2. Press the start key. The value is set.
3. To return to the screen for selecting an item, press the stop/clear key.
Setting the Ta time-out time
In fax/telephone auto select mode, sets the time during which rings to call
an operator continue through the connected telephone after receiving a
call as a fax machine (see the diagram on the following page). A fax signal
is received within the Ta set time, or fax mode is selected automatically
when the time elapses. In fax/telephone auto select mode, change the
setting when fax reception is unsuccessful or a telephone fails to receive a
call.
1. Change the setting using the numeric keys.
Description
Ta time-out time
Setting range Initial setting
1 to 255 s 30
2. Press the start key. The value is set.
3. To return to the screen for selecting an item, press the stop/clear key.
Setting the Tb time-out time
In fax/telephone auto select mode, sets the time to start rings to call an
operator through the connected telephone after receiving a call as a fax
machine (see the diagram on the following page). In fax/telephone auto
select mode, change the setting when fax reception is unsuccessful or a
telephone fails to receive a call.
1. Change the setting using the numeric keys.
Description
Tb time-out time
Setting range Initial setting Change in value per step
1 to 255 50 100 ms
2. Press the start key. The value is set.
3. To return to the screen for selecting an item, press the stop/clear key.