2-11
2
2
2
2
13
Pull out the roll media out.
(1)
Raise the clamp lever from the front of this
machine.
(2)
Pull out the roll media gently.
14
Push down the clamp lever from the front
of this machine.
15
Hold the media with the media press
gently.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
• When using a thick media, remove the media
press from the media before printing.
16
Prepare for the take-up device.
(1)
Set the taking-up direction switch to “OFF”
(Center)
(2)
Set the taking-up manual switch to “Auto”
(Lower)
17
Raise the tension bar on the front side to
the highest position, and lock the bar.
18
Feed the media to the tension bar.
(1)
Pressing the [
] key, feed the media until the
tension bar at the rolling side is being hidden.
• Check the media end is not caught into the
slot on the platen, and feed the media.
19
Fix the media to the roll shaft.
(1)
Route the media from the front side of the
tension bar, and fix the media in the center of
the roll shaft with adhesive tape.
Media Press
Taking-up
manual
Forward
Taking-up with the print side
facing to the outside.
OFF
Not operated.
Manual
Auto
Taking-up direction
Backward
Taking-up with the print side
facing to the inside.
Tension bar
Lock
Roll shaft
Tape
Tension bar
Roll up with the print-
side outside.
Roll up with the print-
side inside.
Recommendation
Summary of Contents for SIJ-320UV
