2-14
5
Move the roll holder C to the center of this
machine, and the roller holders R and L to
the right and left ends of this machine
respectively.
• Follow the steps below to move the roll holders.
(1)
Loosen the roll holder fixing screw.
(2)
Move the roll holders R, and L to the right,
and left of this machine respectively.
(3)
Move the roll holders C to the center of this
machine, and tighten the fixing screw of roll
holder C.
• This machine has a mark indicating its
central position to allow the roll holder C to be
set.
• Tighten the screw firmly to secure the roll
holder C at its proper position.
6
Set media in the roll holder.
• Set the media one by one.
(1)
Set the roll tables as shown in the figure and
temporarily place the media on top of the
tables.
• Keep a proper space between the tables to
stabilize the media.
(2)
Insert the paper core of the media into the
roll holder C.
• Push the roll media onto the roll holder until
the roll core is all the way seated.
(3)
Insert the roll holder R (or L) into the paper
core, and tighten the fixing screw.
• Tighten the screw so firmly that the roll holder
will not move during printing.
(4)
Remove the roll tables, and move the tables
to allow the other media to be set.
• To remove a roll table, raise its near side and
pull out the table obliquely upward as shown
in the figure.
(5)
Set the other media in the same way as
described in steps (2) and (3).
(6)
Remove the roll tables and store the tables.
Roll holder fixing screw
Roll holder fixing screw
sets to be between
mark
Roll table
Summary of Contents for SIJ-320UV
