MIMAKI SIJ-320UV, Operation Manual

Page: 41 / 124

2-13
2
2
2
2
Setting two narrow roll media
(twin rolls)
1
Set the settings of “Feeding Unit” and
“Take-up Unit” of the Machine Setup to
OFF.
• Refer to P.3-13 “Setting Feeding unit” and P.3-13
“Setting Take-up unit”.
2
Open the front cover and rearciver.
3
Rise the clamp lever.
4
Add the attached media press to hold the
two media.
(1) Remove the left side maintenance cover.
• Rotate the screws under the left side
maintenance cover (for three positions) to the
left and remove them.
• Hold the bottom of the left maintenance
cover, and pull the cover toward you from
below to remove the cover.
• If the left side maintenance cover is hard to
remove, use the supplied screwdriver.
(2) Remove the sheet metal in the figure below.
(3) Attach the Media press in the accessories.
• Fit the protruding portion of the media press
into the groove of the platen (circle part in the
figure below).
(4) Return the sheet metal that was removed in
step (1) to the original position and attach the
left side maintenance cover.
Pay attention to the following when printing on
twin rolls.
• Use media having a media width of 1524 mm or
less and a paper core width of 1550 mm or less.
• Set two media having the same properties as
shown below. Otherwise, the printed image quality
will be affected.
Media type, media grade, media width, the
diameter of media to be set (with the same
remaining media amount), and media rolling-up
direction
Front cover
Rear cover
Clamp lever
• There is a direction to
the media press.
Please install the left
and right properly.
Screw
Left side
Rotate it left.
Remove the center screw, and remove.
Left
side
Right
side