Technical Information
90
G 600/G 800
Programming Flow Chart
Enter
Service Mode 2
To access:
Fault codes
Program index
Increased water temperature selection
Water softener (with/without)
Extended drying 45 minutes
Interim rinses
Dishwasher width setting
EGS (Plus models only)
Table 6-13:
G 811, G 851, G 851 Plus, G 856, G 856 Plus Programming Flow Chart
6.8.3.1 Programming
Mode
1. To access the
programming mode
,
close the door and turn the program
selector switch to
Stop
. Turn the dishwasher off.
2. Press and hold the
Top solo
button while turning the dishwasher on. Release
the
Top solo
button within 2 seconds. A blinking
Salt
light indicates successful
accessing of the
programming mode
.
3. Turn the program selector switch to the position indicated in Table 6-14 to modify
the corresponding function.
4. Use the
Top solo
button to toggle the functions on or off.
5. After selecting options, turn the program selector switch to
Stop
and turn the
dishwasher off.
Selector switch
position (o’clock)
Function
Options
Status of Start light
1 to 8
Water hardness
See Section 6.8.3.1.1 Light 1 to 8 on
1
9
Extended drying (14
minutes)
On
2
Off
Off
On
11 Water
intake
time
70 seconds
2
100 seconds
Off = 70 sec
On = 100 sec
Table 6-14:
G 811, G 851, G 851 Plus, G 856, G 856 Plus Programming Functions
1
If no lights light up, the dishwasher is programmed for “without water softener”. To change to
“with water softener”, follow the steps in Service Mode 2 (Section 6.8.3.3).
2
Factory setting
6.8.3.1.1
Setting the Water Hardness
1. Measure the water hardness in grains per gallon (gpg).
2. Access
Programming Mode
.
3. Using Table 6-15 below, turn the program selector switch to the corresponding water
hardness position, e.g., for water hardness = 10 gpg, turn the program selector switch to
the 3 o’clock position.
4. Press
the
Top solo
button once. The
Top solo
light will light up.
5.
To save:
Press the
Start
button (
Start
light lights up), turn the program selector switch to
Stop
and turn the dishwasher off.
Water hardness in gpg
Selector switch position (o’clock)
1-4 1
5-7 2
8-10 3
11-14 4
15-17 5