Technical Information
111
G 600/G 800
Example:
Sani Wash:
007
Normal 150:
127
Total operating hours: 7.127 hours
6.8.9
G 892, G 832
Programming Flow Chart
Enter
Programming Mode
To access:
Water hardness settings
Heated drying (on/off)
Enter
Service Mode 1
To access:
Manual step mode
Component test program
Enter
Service Mode 2
To access:
Error messages
Program index number
Increased water temperature selection
Water softener (with/without)
Extended water intake
Extended drying fan time
Dishwasher width setting
EGS
Table 6-45:
G 892, G 832 Programming Flow Chart
6.8.9.1 Programming
Mode
1. To access the
programming mode
,
close the door and turn the dishwasher on.
The
Start/Stop
light
must
be blinking. If the
Start/Stop
light is
not
blinking, press
and hold the
Start/Stop
button for at least 3 seconds to exit the cycle. The
Start/Stop
light should now be blinking.
2. Turn the dishwasher off.
3. Press and hold the
Start/Stop
button while turning the dishwasher on. Release
the Start/Stop button within 2 seconds. Successful accessing of the
programming mode
is indicated by a blinking
Salt
light and a lit or flashing
Rinse
light.
Note:
If the
Rinse
light is neither lit nor flashing, the machine has been programmed
to “without softener”. See
Service Mode 2
(Section 6.8.9.3)
to turn the water
softener on or off.
6.8.9.1.1
Setting the Water Hardness
1. Measure the water hardness in grains per gallon (gpg).
2. Access
Programming Mode
.
3. Using Table 6-46 below, press the down arrow button to choose the corresponding
program for setting the correct water hardness (e.g., “Normal Plus” = 8 to 11 gpg).