Technical Information
100
G 600/G 800
6. If the dishwasher door is opened and closed or the dishwasher is turned off and
on, the service mode will be canceled and the machine will continue to advance
normally.
6.8.5.2.1 Test
Program
The test program is a program that allows the technician to check all of the major functions of
the dishwasher.
1. Access
Service Mode 1
.
2. Turn the program selector switch to the 11 o’clock position and press the
Start
button.
The test program will start and advance automatically.
3. Pressing
the
Start
button repeatedly will allow the technician to advance through the
program. If the
Start
button is not pressed, the program will run automatically.
6.8.5.3
Service Mode 2
Service Mode 2
is used to determine which upper electronic is in the machine, to
change certain programmed functions and to access fault codes. The programmed
functions include setting the flow meter, increasing the water temperature, turning on
or off the water softener, increasing the water level, extending the circulation fan
time, adding an interim rinse, and setting the dishwasher width (18” or 24”).
1. To access
Service Mode 2
, close the door and turn the selector switch to
Stop
.
2. Turn the dishwasher off.
3. Press and hold the
Top solo
and
Start
buttons while turning the dishwasher on.
A dot (.) in the display and a flashing
Intake/Drain
light indicates successful
accessing of
Service Mode 2
.
4. Turn the program selector switch to the appropriate position in Table 6-28 to
access the various functions of
Service Mode 2
.
5.
To save:
Press the
Top solo
button twice, turn the program selector switch to
Stop
and turn the dishwasher off.
Selector switch
position (o’clock)
Function Options
Display
1
Fault codes
-
F00, F01, etc.
2
Operating hours
-
e.g., 007
3
Operating hours
-
e.g., 127
4
Flow meter
195 to 205
195 to 205
5
Increase temperature
150°F 50
160°F 51
6 Water
softener
With
1
60
Without 61
7
Increase water intake
Without 70
With 71
8
2 interim rinses
Off 80
On 81
9
Extended drying fan time
2
Off 90
On 91
Table 6-28:
G 681, G 881 Novo Stella, G 886 Novo Stella Plus Service Mode 2 Functions
1
Factory setting
2
Can only be extended if “+14 min” is selected in programming mode. See Section 6.8.5.1.
