Technical Information
117
G 600/G 800
Stage
Stage function
Illuminated light
Stage 1
Fault codes
Rinse
Stage 2
Program index
Drying
Stage 3
Function programming
End
Table 6-54:
G 694, G 894 Service Mode 2 Stages
6.8.10.3.1 Stage
1
1. To
access
Stage 1
of
Service Mode 2,
close the door and turn the dishwasher on. The
Start/Stop
light
must
be blinking. If the
Start/Stop
light is
not
blinking, press and hold
the
Start/Stop
button for at least 3 seconds to exit the cycle. The
Start/Stop
light should
now be blinking.
2. Press and hold the
Delay Start
and
Start/Stop
buttons while turning the dishwasher on.
Flashing
Intake/Drain
and
Salt
lights and a lit
Rinse
light indicate successful accessing
of
Stage 1
of
Service Mode 2
.
3. The display will indicate the last fault stored.
4. Use the fault code chart
(Table 6-55)
to determine the stored fault code.
5. To delete stored fault codes, access the
Programming Mode
and press
Start/Stop
twice.
Fault code
Fault
F00 No
error
F01
NTC or NTC connections open-circuited
F02
NTC or NTC connections short-circuited
F03
Electronic failure, selector switch position not found
F04
Heating failure - heating circuit opened or defective electrical
component in heating circuit
F05
Water drainage failure, heater level switch
F06
Too few pulses at flow meter / start of water intake
F07
Too few pulses at flow meter / end of water intake
F08
Water intake failure, heater level switch
F09
Heater level switch not switching on at the end of thermal stops
Table 6-55:
G 694, G 894 Fault Code Chart
6.8.10.3.2 Stage 2
1. To
access
Stage 2
of
Service Mode 2
,
close the door and turn the dishwasher on. The
Start/Stop
light
must
be blinking. If the
Start/Stop
light is
not
blinking, press and hold
the
Start/Stop
button for at least 3 seconds to exit the cycle. The
Start/Stop
light should
now be blinking.
2. Press and hold the
Delay Start
and
Start/Stop
buttons while turning the dishwasher on.
Flashing
Intake/Drain
and
Salt
lights and a lit
Rinse
light indicate successful accessing
of
Service Mode 2
.
3. Press
the
Top solo
button once. Flashing
Intake/Drain
and
Salt
lights and a lit
Drying
light indicate successful accessing of
Stage 2
of
Service Mode 2
.
4. The display will indicate the current electronic version.
5. To save, press the
Start/Stop
button twice.
6.8.10.3.3 Stage
3
1. To
access
Stage 3
of
Service Mode 2,
close the door and turn the dishwasher on. The
Start/Stop
light
must
be blinking. If the
Start/Stop
light is
not
blinking, press and hold
the
Start/Stop
button for at least 3 seconds to exit the cycle. The
Start/Stop
light should
now be blinking.