![background image](http://html.mh-extra.com/html/miele/g-600-series/g-600-series_technical-information_234715099.webp)
Technical Information
99
G 600/G 800
mode
. The display will show a program index number of P00 or P01, depending
on the software version.
3. Turn the program selector switch to the position indicated in Table 6-27 to modify
the corresponding function.
4. Use the
Top solo
button to toggle the functions on or off.
5. After selecting options, press the
Start
button twice, turn the program selector
switch to
Stop
and turn the dishwasher off.
Program Function Chart
Selector switch
position (o’clock)
Function Options Display
2
Water hardness
setting
0 gpg
1
1 - 36 gpg
2
1 - 36 gpg
4 Buzzer
On
2
Off
40
41
9
Extended drying (14
minutes)
70 seconds
2
100 seconds
90
91
Table 6-27:
G 681, G 881 Novo Stella, G 886 Novo Stella Plus Programming Functions
1
If “0” is displayed, the dishwasher is programmed for “without water softener”. To change to “with
water softener”, follow the steps in Service Mode 2 (Section 6.8.5.3).
2
Factory setting
6.8.5.1.1
Setting the Water Hardness
1. Measure the water hardness in grains per gallon (gpg).
2. Access
Programming Mode
.
3. Use
the
Top solo
button to toggle through to the desired water hardness amount.
4.
To save:
Press the
Start
button twice, turn the program selector switch to
Stop
and turn
the dishwasher off.
6.8.5.1.2
Checking the Water Hardness Level
1. Access
Programming Mode
.
2. Turn the program selector switch to the 2 o’clock position.
3. The number in the display will indicate the programmed water hardness setting (see
Table 6-27).
4. Turn the program selector switch to
Stop
and turn the dishwasher off.
6.8.5.2
Service Mode 1
1. To access the
Manual Step Mode
, close the door and turn the program selector
switch to
Stop
. Turn the dishwasher off.
2. Press and hold the
Delay Start
and
Top solo
buttons while turning the
dishwasher on. A dot (.) in the display and lit
Intake/Drain
light indicates
successful accessing of
Service Mode 1.
3. Select a program and press the
Start
button. The display will show the current
program step.
4. Pressing the
Start
button repeatedly will allow the technician to advance through
the program manually. If the
Start
button is not pressed, the program steps are
carried out automatically, in their normal order.
5.
Service Mode 1
can be activated at any time during a program wash cycle.
When it is activated at any time during a program wash cycle, the display will
show the current program step.
Note:
The program chart in the wiring diagram should be used to follow the
machine functions when stepping through a program.