Technical Information
113
G 600/G 800
6.8.9.2.1 Test
Program
The test program is a program that allows the technician to check all of the major functions of
the dishwasher.
1. Access
Service Mode 1
.
2. Using the arrow buttons, select the
Rinse & Hold
program and press the
Start/Stop
button. The test program will start and advance automatically.
3. Pressing
the
Start/Stop
button repeatedly will allow the technician to advance through
the program. If the
Start/Stop
button is not pressed, the program will run automatically.
6.8.9.3
Service Mode 2
Service Mode 2
is used to determine which upper electronic is in the appliance, to
change programmed functions and to access fault codes. Programmed functions
include increasing the water temperature, turning on or off the water softener, adding
an interim rinse, and setting the dishwasher width (24”).
Service Mode 2
is divided
into 3 stages.
Stage
Stage function
Illuminated light
Stage 1
Fault codes
Rinse
Stage 2
Program index
Drying
Stage 3
Function programming
End
Table 6-48:
G 892, G 832 Service Mode 2 Stages
6.8.9.3.1 Stage
1
1. To
access
Stage 1
of
Service Mode 2,
close the door and turn the dishwasher on. The
Start/Stop
light
must
be blinking. If the
Start/Stop
light is
not
blinking, press and hold
the
Start/Stop
button for at least 3 seconds to exit the cycle. The
Start/Stop
light should
now be blinking.
2. Press and hold the
Start/Stop
button while turning the dishwasher on. Release the
Start/Stop
button and immediately press it 2 more times. Flashing
Intake/Drain
and
Salt
lights and a lit
Rinse
light indicate successful accessing of
Stage 1
of
Service Mode 2
.
3. Use
the
fault code chart
(Table 6-49)
to determine the stored fault code. Example: A lit
Normal Plus
light and a lit
Rinse
light = NTC or NTC connections short-circuited.
4. To delete stored fault codes, access the
Programming Mode
and press
Start/Stop
twice.
Fault code
Program light and
status
Rinse light
status
Fault
F00
Pots & Pans
Lit
Lit
No error
F01
Sani Wash
Lit
Lit
NTC or NTC connections open-
circuited
F02
Normal Plus
Lit
Lit
NTC or NTC connections short-
circuited
F03
Normal
Lit
Lit
Electronic failure, selector switch
position not found
F04
Economy
Lit
Lit
Heating failure - heating circuit
opened or defective electrical
component in heating circuit
F05
Rinse & Hold Lit
Lit
Water drainage failure, heater
level switch
F06
Pots & Pans
Lit
Flashing
Too few pulses at flow meter /
start of water intake
F07
Sani Wash
Lit
Flashing
Too few pulses at flow meter /
end of water intake
