Technical Information
75
G 600/G 800
6.2.7
With or Without Water Softener
Used to enable or disable the water softener system.
“With water softener” = Water softener is ON
“Without water softener” = Water softener is OFF
Note:
If the water softener is not needed, the electronic should be programmed to “without
water softener.” If the electronic is programmed to “with water softener,” the
hardness value (gpg/ppm) must be programmed. See the model-specific operating
manual for further information.
6.2.8
2nd Interim Rinse
An additional rinse between the first rinse and the final rinses can be added. Refer to
the model-specific programming/service mode section for further details.
6.2.9
Width of Machine (As Applicable)
Some electronics can be installed in more than one model, and, therefore, require
programming the width of the dishwasher (full-size or Slimline) in which they are
being installed. Refer to the model-specific programming/service mode section for
further details.
6.2.10
Flow Meter Count
Stores the “numeric value” marked on the side of the flow meter to ensure proper
operating conditions.
Note:
To ensure proper appliance operation, the flow meter count must be reprogrammed
after installation of a new flow meter and/or electronic.
6.2.11
Operating Hours
Records the duration (in hours) the appliance has been operated.
6.3
Programming/Service Mode Access Procedures (Model-
Specific)
Refer to the service mode guide located at the end of this section.
