![background image](http://html.mh-extra.com/html/miele/g-600-series/g-600-series_technical-information_234715101.webp)
Technical Information
101
G 600/G 800
6.8.5.3.1
Accessing Fault Codes
1. Access
Service Mode 2
.
2. Turn the program selector switch to the 1 o’clock position.
3. The fault code will be shown in the display, e.g., F01, F02, etc.
4. Use the fault chart (Table 6-29) to determine which fault has been stored in the
dishwasher.
5. Turn the dishwasher off.
Fault code
Fault
F00 No
error
F01
NTC or NTC connections open-circuited
F02
NTC or NTC connections short-circuited
F03
Electronic failure, selector switch position not found
F04
Heating failure - heating circuit opened or defective
electrical component in heating circuit
1
F05
Water drainage failure, heater pressure switch
F06
Too few pulses at flow meter / start of water intake
F07
Too few pulses at flow meter / end of water intake
F08
Water intake failure, heater pressure switch
F09
Heater pressure switch not switching on at the end
of thermal stops
3 dashes (---) in display
Indicates a F1, F2, F4, or F9 fault is stored in the
memory
Table 6-29:
G 681, G 881 Novo Stella, G 886 Novo Stella Plus Fault Code Chart
1
All wash programs can be run, but the heating element will not function during the cycle.
6.8.5.3.2
Deleting Stored Fault Codes
1. Access
Programming Mode
.
2. Press
the
Start
button twice
and turn the dishwasher off.
6.8.5.3.3 Operating
Hours
1. Access
Service Mode 2
.
2. Turn the program selector switch as shown in Table 6-30 below.
Selector switch position
Display
2
First 3 digits of total operating hours
3
Last 3 digits of total operating hours
Table 6-30:
G 681, G 881 Novo Stella, G 886 Novo Stella Plus Operating Hours
Example:
2 o’clock position: 007
3 o’clock position: 127
Total operating hours: 7.127 hours
6.8.6 G
885