![background image](http://html.mh-extra.com/html/miele/g-600-series/g-600-series_technical-information_234715124.webp)
Technical Information
124
G 600/G 800
1. To access
Service Mode 2
,
close the door and turn the dishwasher on. All
program lights should light. If not, press the
Start/Stop
button to cancel the
program. Turn the dishwasher off.
2. Press and hold the
Top solo
and
Start/Stop
buttons while turning the
dishwasher on. Successful accessing of
Service Mode 2
is indicated by a dot (.)
in the display and flashing
Drain
and
Salt
lights.
3. Press the appropriate program button indicated in Table 6-64 to modify the
corresponding function.
4. Use the
Top solo
button to toggle through the function settings.
5. To save: Press the
Start/Stop
button twice and turn the dishwasher off.
Program button
Function
Options
Display
Pots & Pans
Fault codes
-
F00, F01, etc.
Sani Wash
Operating hours
-
e.g., 001
Normal Plus
Operating hours
-
e.g., 127
Normal EGS
On 40
Off 41
China/Crystal Increase temperature
150°F 50
160°F 51
Light Wash
Water softener
With
1
60
Without 61
Economy
Increase water level
Standard 70
Increased 71
Short Interim
rinses
1 80
2 81
Energy saver
Extended drying
1
14 minutes
90
45 minutes
91
Table 6-64:
G 898 Service Mode 2 Functions
1
Factory setting
6.8.12.3.1 Accessing Fault Codes
1. Access
Service Mode 2
.
2. Press
the
Pots & Pans
program button.
3. The fault code will be shown in the display, e.g., F01, F02, etc.
4. Use the fault chart (Table 6-65) to determine which fault has been stored in the
dishwasher.
5. Turn the dishwasher off.
Fault code
Fault
F00 No
error
F01
NTC or NTC connections open-circuited
F02
NTC or NTC connections short-circuited
F03
Electronic failure, selector switch position not found
F04
Heating failure - heating circuit opened or defective
electrical component in heating circuit
F05
Water drainage failure, heater level switch
F06
Too few pulses at flow meter / start of water intake
F07
Too few pulses at flow meter / end of water intake
F08
Water intake failure, heater level switch
F09
Heater level switch not switching on at the end of thermal stops
Table 6-65:
G 898 Fault Code Chart