Technical Information
10
G1000 / G2000 Dishwashers
Warnings and Safety Information
Service and repair work should only be carried out by suitably qualified persons in
accordance with all appropriate local and national safety regulations.
Before any service work is started, the appliance must be disconnected from the
power supply.
If it is necessary to tip the machine when working on the lower areas, it may only be
tilted onto its back. On models with salt container in the sump, the following must be
performed:
Empty the water inlet mixer: Open the salt container cap briefly, reinstall the cap and
ensure it is firmly secured. Any remaining water should then be removed from the
cabinet.
Upon completion of any service procedures, a short wash program without load
should be run. This is to remove any salt residues that might be present and prevent
possible corrosion.
If the retaining nut to the salt container becomes loose during repair work, the salt
container can slip out of the connection to the water inlet mixer. Should this occur the
salt container must be dismantled. To avoid leaks and additional procedures ensure
the salt container is supported via the service opening.
Do not tilt the unit onto its right side, as this would cause water to run into the fan.
Many procedures will require the machine to be placed on its back. Care should be
taken to avoid damage to the water hoses and power cord.
For questions, concerns, clarifications or further assistance contact the Miele
Technical Support Center at 1-800-999-1360.
