Page 25
Installation and Initial Operation
thicknessCONTROL MTS 8202.LLT / 4350127.347
4.7
Position of Measurement Object
The measuring ranges of the used sensors are decisive when positioning the target in
the measuring gap. The target must be within both sensor measuring ranges for a cor-
rect thickness measurement.
Guide the target through the measuring system at the correct installation height.
Take appropriate measures, e.g. guide rollers, to ensure that the target does not
collide with the measuring system.
Measuring range
Location
tolerance
target
Target
1
Fig. 25 Parameters for positioning the target
W
orking gap
Sensor 1
Sensor 2
MR
D
MR
Measuring range of the measuring system and
measuring range sensor 1/2
The measuring range is the vertical area in which
recording takes place during measurements. It
results from the thickness tolerance as well as the
vertical movement of the target.
Maximum material thickness of the measured object
Oper-
ating
range
Distance between the upper belt and lower belt
A large working gap reduces the danger of damage
to the measuring machine during extremely vertical
movements of the measured object. Vertical area
in which the measured object can move during the
currently running measurement. Here the meas-
uring object may leave the measuring range of
the sensors temporarily exceeded if the material
locations are extremely high (lift-off, wave formation,
etc.). The measuring system must not be damaged.
D
Thickness of the measured object
The individual values for the variables are available
in the attachment
.
Fig. 26 Positioning tolerance of target for measuring its thickness
NOTICE
Danger of collision. The
measuring system may
be damaged by the
measured object. Move
the measured object
through the measuring
system with suitable
tools to ensure that the
measured object and
measuring system can-
not collide.
1
Characteristics of target
material:
Width:
min. 1000 mm
max. 3300 mm
Thickness:
min. 6.5 mm
max. 280 mm
CAUTION
If belt material is hot:
danger of burns from
belt material (measured
object). Only touch the
belt material (measured
object) with suitable safe-
ty gloves.
Summary of Contents for 4350127.347
