MICRO-EPSILON 4350127.347, Operating Instructions Manual

Page: 59 / 68

Page 59
Maintenance, Service, Spare Parts Lists
thicknessCONTROL MTS 8202.LLT / 4350127.347
7. Maintenance, Service, Spare Parts Lists
7.1 Maintenance
7.1.1 General Maintenance
Pay attention to unusual operating noises for the maintenance work.
Maintenance intervals, especially the intervals for re-greasing, are affected by e.g.,
traversing speed/drive torque, load, temperature, ambient conditions (cleanliness, etc.).
Not all effects on maintenance intervals can be determined mathematically. The intervals
can therefore only be specified in detail under operating conditions.
7.1.2 Maintenance Plan
Daily Maintenance
Work to be performed Tools, equipment, measuring equip-
ment Staff code
Check the optical open-
ings for dirt. Clean them as
required.
Visual inspection; lint-free cloth,
lens cleaning paper or cotton swabs
and pure alcohol (isopropanol)
see cleaning instructions 01
Monthly Maintenance
Work to be performed Tools, equipment, measuring equip-
ment Staff code
Check the guide rails and
the seals of the carriages for
damage.
Visual inspection 02
Clean the linear guides as
required.
Lint-free cloth, oil 02
Check the dirt pan and the
sheet steel wipers on the
measurement carriage for
wear.
Visual inspection 02
Check condensate sep-
arator and fill level of the
maintenance unit. If nec-
essary, drain accumulated
condensate.
Visual inspection 02
Quarterly maintenance
Work to be performed Tools, equipment, measuring equip-
ment Staff code
Test the measuring system’s
emergency stop circuit.
Function test 01
Check the filter pads of
the control cabinet for dirt.
Replace the filters if they are
very dirty.
Visual inspection 01
Clean the master part if
necessary.
Visual inspection, use cotton gloves
or a lint-free cloth 02
Complete the lubrication of
the guide carriages.
Multi-purpose grease LGMT2 02
Check the cable trailing
device and the cables in the
cable carrier for damage.
Visual inspection 01
NOTICE
Running noise and vibra-
tions at the measuring
system can be triggered
by wear. Perform all
tasks in the maintenance
instructions to prevent
greater material damage
to the measuring system.
CAUTION
Danger of crushing or
shearing. Perform clean-
ing or maintenance work
when the power supply
is disconnected and se-
cured, if at all possible.
Legend
Staff code
01 = Electrician
02 = Mechanical engi-
neer
CAUTION
Damage due to unsuit-
able cleaning tools or
cleaning materials.
NOTICE
Machine cleaning cloths
that are extremely absor-
bent, tear-resistant and
retain their shape are
recommended. The re-
quirements of DIN 61651
should be met.