FCM9002 USER MANUAL
76-02-095 Rev.B
Page 42 of 145
rt.1.p=2
snmp.n=FCM9002
snmp.l=Test Network
welcome.0=This is an example
welcome.1=of a customised
welcome.2=Welcome Screen
welcome.4=You may define upto
welcome.5=8 lines of text.
welcome.8=Here is line number 8
To return the main system menu, stop the text capture and hit any key to
proceed.
4.1.7 Input Config
If a config file has been captured it may be reloaded to the unit using the Input
Config command.
Selecting Input Config gives the following message:
Send File. Esc to end.
Use a send text file option from the terminal package, and select the stored
configuration file. Once the file has been sent, type ESC to finish.
Once loaded the unit will reboot to load the configuration.
If errors are detected in the configuration file, the first error will be reported with
the line number.
4.1.8 Warm Start
A warm start will force the unit to reboot and reload the configuration stored in
the EEPROM. Note, any changes to the configuration made that have not been
saved WILL be lost.
When a TELNET user issues a warm start request, the FCM9002 will indicate
that a warm start is about to take place, and then close the connection.
4.1.9 Cold Start
A Cold Start will erase the configuration EEPROM and return the unit to the
factory default condition as defined by the bit switch settings.
Note, that a cold start will erase all IP addresses and routing table entries and it
is highly likely that remote access will be lost following a cold start.
