FCM9002 USER MANUAL
76-02-095 Rev.B
Page 23 of 145
ON
Full Duplex
OFF
Half Duplex
Note,
When the fibre interface is selected, only Full Duplex modes are supported.
2.2.2 Zero Touch Configuration Control
There are two bit switches concerned with the setup of the unit to support the
zero touch configuration mode. When the FCM9002 uses the Zero Touch, Auto
Boot intialisation it will listen for a beacon on the selected WAN. The beacon
allows the FCM9002 to determine the correct tag values to use for a
management connection to DHCP/TFTP/SNMP servers.
2.2.2.1 Switch 7, Boot Location / (Autoboot)
This switch enables the autoboot, Zero Touch Configuration mode.
ON
Auto Boot, ZTC enabled
OFF
Disabled, boot from local configuration
When auto boot is enabled the FCM9002 will listen for a beacon on the WAN
port and then use the information gathered from this beacon to set up a
management channel connection to DHCP and TFTP servers, and also to an
SNMP manager.
